cnc shield burns ( literally)

Post Reply
mad Unfocused
Posts: 1
Joined: Wed May 13, 2020 4:48 pm

cnc shield burns ( literally)

Post by mad Unfocused » Wed May 13, 2020 5:13 pm

I bought a cnc shield some time ago to replace the brain of an XYZ Leonardo jr 3d printer because the Leonardo jr was so locked down it was rediculous. I got it all hooked up to the three axies and it ran great for about fifteen seconds at which point part of the board lit up (fire). I got a replacement and the same area started to get hot.
What information do y'all need to help me figure out how to make this work?
Screenshot_20200513_110632.jpg
Screenshot_20200513_110632.jpg (428 KiB) Viewed 47 times
Screenshot_20200513_110758.jpg
Screenshot_20200513_110758.jpg (103 KiB) Viewed 47 times
I jumpered past the burnout and it works... Except the wire gets really hot.

Bertus Kruger
Site Admin
Posts: 1649
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: cnc shield burns ( literally)

Post by Bertus Kruger » Thu May 14, 2020 12:46 am

I would suggest you get the latest version : https://www.elecrow.com/arduino-cnc-shi ... ivers.html

It can run the latest GRBL version.


V3 - This was the build guide for that version...

https://blog.protoneer.co.nz/arduino-cn ... bly-guide/

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests