Magnetic loop controller for 4 antennas

Please share your projects...
Post Reply
cabrinana2
Posts: 2
Joined: Sun Mar 01, 2020 2:37 pm

Magnetic loop controller for 4 antennas

Post by cabrinana2 » Sun Mar 01, 2020 2:44 pm

Hi.
i'm currently working in a project that uses this cnc shield :
https://blog.protoneer.co.nz/arduino-cn ... /#Assemble
I have posted it in instructables where I have post a link to your blog.
Do I have permission to use the photos in your blog to illustrate my project ?
Thanks ;)

Bertus Kruger
Site Admin
Posts: 1594
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Magnetic loop controller for 4 antennas

Post by Bertus Kruger » Wed Mar 04, 2020 6:24 pm

cabrinana2 wrote:
Sun Mar 01, 2020 2:44 pm
Hi.
i'm currently working in a project that uses this cnc shield :
https://blog.protoneer.co.nz/arduino-cn ... /#Assemble
I have posted it in instructables where I have post a link to your blog.
Do I have permission to use the photos in your blog to illustrate my project ?
Thanks ;)
Go for it.... Please post a link of your instructables... :)

cabrinana2
Posts: 2
Joined: Sun Mar 01, 2020 2:37 pm

Re: Magnetic loop controller for 4 antennas

Post by cabrinana2 » Thu Mar 12, 2020 6:54 pm

Hi,
I have two projects .
The first one is a four antennas controller:

https://www.instructables.com/id/Magnet ... -Antennas/

The second one is a version with only three antennas capability but equipped with endstop possibility:

https://www.instructables.com/id/Contro ... ith-Endst/

Thanks in advance.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest