Cnc hat driver issue

Post Reply
Dpittmanw
Posts: 1
Joined: Sat Feb 08, 2020 7:34 pm

Cnc hat driver issue

Post by Dpittmanw » Sat Feb 08, 2020 7:38 pm

I have the 2.60 cnc hat and any stepper plugged into x axis just jerks all others move. If swap drivers or moters same issue. Voltage is 6. Any help would be great

Bertus Kruger
Site Admin
Posts: 1678
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Cnc hat driver issue

Post by Bertus Kruger » Tue Feb 11, 2020 6:48 pm

Dpittmanw wrote:
Sat Feb 08, 2020 7:38 pm
I have the 2.60 cnc hat and any stepper plugged into x axis just jerks all others move. If swap drivers or moters same issue. Voltage is 6. Any help would be great
HAve you tried to increase the micro stepping? HAve you wired the stepper cables correctly?

The above could cause the motors to jerk... ;)

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests