Wanted a free or cheap Cam program

Post Reply
erniehatt
Posts: 256
Joined: Thu Nov 03, 2016 8:16 am

Wanted a free or cheap Cam program

Post by erniehatt » Mon Oct 28, 2019 10:50 pm

Any suggestions anyone, please. ;)

ckoppenaal
Posts: 13
Joined: Fri May 18, 2018 1:11 pm

Re: Wanted a free or cheap Cam program

Post by ckoppenaal » Tue Oct 29, 2019 1:37 pm

I think Fusion 360 is free software for hobbyist

erniehatt
Posts: 256
Joined: Thu Nov 03, 2016 8:16 am

Re: Wanted a free or cheap Cam program

Post by erniehatt » Wed Oct 30, 2019 8:57 am

Thanks for the reply.
I have Fusion 360, but use Sketchup for most things, and have just found an extension for Cam, which, after a little playing around, find it to works really well.

Mochanic
Posts: 27
Joined: Mon Nov 12, 2018 10:41 pm

Re: Wanted a free or cheap Cam program

Post by Mochanic » Sat Nov 09, 2019 2:33 am

erniehatt wrote:
Wed Oct 30, 2019 8:57 am
Thanks for the reply.
I have Fusion 360, but use Sketchup for most things, and have just found an extension for Cam, which, after a little playing around, find it to works really well.
Mind sharing? I too use SU and have been wondering about this.

erniehatt
Posts: 256
Joined: Thu Nov 03, 2016 8:16 am

Re: Wanted a free or cheap Cam program

Post by erniehatt » Sat Nov 09, 2019 8:55 am

Not at all.
It's a free extension, you download it from SketchUCam.com.
It take a bit of working out, but there are a number of videos that explain, some good and some not so good.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests