Can someone please help

Post Reply
MNpCM
Posts: 1
Joined: Thu Aug 01, 2019 1:19 am

Can someone please help

Post by MNpCM » Thu Aug 01, 2019 1:21 am

Where do I connect the ground wire for the cnc end stops and where do I connect the other wire for the end stop. I am stuck and have been stuck on this part for the last several months.

Bertus Kruger
Site Admin
Posts: 1560
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Can someone please help

Post by Bertus Kruger » Tue Aug 06, 2019 7:42 pm

MNpCM wrote:
Thu Aug 01, 2019 1:21 am
Where do I connect the ground wire for the cnc end stops and where do I connect the other wire for the end stop. I am stuck and have been stuck on this part for the last several months.
Any of the pins marked as ground can be used. (They are all internally connected.)

Mochanic
Posts: 36
Joined: Mon Nov 12, 2018 10:41 pm

Re: Can someone please help

Post by Mochanic » Sat Nov 16, 2019 2:40 am

Bertus Kruger wrote:
Tue Aug 06, 2019 7:42 pm
MNpCM wrote:
Thu Aug 01, 2019 1:21 am
Where do I connect the ground wire for the cnc end stops and where do I connect the other wire for the end stop. I am stuck and have been stuck on this part for the last several months.
Any of the pins marked as ground can be used. (They are all internally connected.)
THIS is exactly the kind of information that SHOULD be on your WIKI page! It's ridiculous that we have to go on a freakin mission to find this kind of important information! You cannot just assume that everybody knows this! You designed this, so unless you tell us how are we supposed to know?
I could write a book about all the questions that I have on this product!

Post Reply

Who is online

Users browsing this forum: Google [Bot] and 2 guests