Layout for 3.51

Question/Answers related to this version of the board.
Post Reply
cparsons
Posts: 1
Joined: Wed Jun 19, 2019 7:46 am

Layout for 3.51

Post by cparsons » Wed Jun 19, 2019 7:51 am

Just received my shield, and noticed the PCB is now at version 3.51 and doesn't quite match the layout shown - I assume the 'fuse' and resistor are
no longer required? Or have been replaced by the SMD components?

Other than that I guess the assembly instructions are the same?

Regards

Chris

Bertus Kruger
Site Admin
Posts: 1490
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Layout for 3.51

Post by Bertus Kruger » Tue Jun 25, 2019 7:11 pm

cparsons wrote:
Wed Jun 19, 2019 7:51 am
Just received my shield, and noticed the PCB is now at version 3.51 and doesn't quite match the layout shown - I assume the 'fuse' and resistor are
no longer required? Or have been replaced by the SMD components?

Other than that I guess the assembly instructions are the same?

Regards

Chris
Yes. We have moved some of the components to SMD and added extra filters on the end stops. The fuse is not used anymore

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests