slight problem

Post Reply
erniehatt
Posts: 234
Joined: Thu Nov 03, 2016 8:16 am

slight problem

Post by erniehatt » Mon Jun 17, 2019 7:22 am

HI Bertus,
since connecting the new board I have had a slight problem occur, none of the motors are turning I can feel and hear a click when I jog them, but no real turning this is on all axis's.
They all worked as they should on the 2.58 board.
I am not sure, but I think the 2.60 has different connectors, but I have used the ones from the 2.58,not sure if this has some effect or not.
I will change one over and see if it does anything.

erniehatt
Posts: 234
Joined: Thu Nov 03, 2016 8:16 am

Re: slight problem

Post by erniehatt » Thu Jun 20, 2019 12:42 am

Tried the plug change, it had no effect what so ever.
I must point out that I made no changes to any connection, I just replaced the board and connected the drivers.
Am I missing something.

Bertus Kruger
Site Admin
Posts: 1457
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: slight problem

Post by Bertus Kruger » Tue Jun 25, 2019 7:29 pm

erniehatt wrote:
Thu Jun 20, 2019 12:42 am
Tried the plug change, it had no effect what so ever.
I must point out that I made no changes to any connection, I just replaced the board and connected the drivers.
Am I missing something.
Hi... Yes. the Plugs have changed from 3.5mm to 3.81mm.

Mmmm not sure why its not moving though.

Bertus Kruger
Site Admin
Posts: 1457
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: slight problem

Post by Bertus Kruger » Tue Jun 25, 2019 7:42 pm

erniehatt wrote:
Thu Jun 20, 2019 12:42 am
Tried the plug change, it had no effect what so ever.
I must point out that I made no changes to any connection, I just replaced the board and connected the drivers.
Am I missing something.
Is the current set on the drivers? Are they powered? .....

erniehatt
Posts: 234
Joined: Thu Nov 03, 2016 8:16 am

Re: slight problem

Post by erniehatt » Thu Jun 27, 2019 9:29 pm

Yes Bertus, They must be, as they worked OK on the 2.58 board, I changed nothing except to change over to the 2.60.
Was there any settings that I should have changed.
All leds are lit there is obviously something getting through as I can feels a click at the start and finish of the run, and I can hear a slight sound , as though they are trying to move.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest