STARTCNC.JS gets stuck

Post Reply
baalhazor
Posts: 1
Joined: Sun Jun 02, 2019 6:00 am

STARTCNC.JS gets stuck

Post by baalhazor » Sun Jun 02, 2019 6:12 am

Everything was working perfectly but for reasons I won't go into, I had to re-burn the CNC image to my micro sd. I ran the serial config script. Now STARTCNC.JS gets stuck at "starting the server at http://127.0.11:8000".

I've tried everything imaginable. Tested the serial port, updated everything, etc. Can anyone help me?

Bertus Kruger
Site Admin
Posts: 1475
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: STARTCNC.JS gets stuck

Post by Bertus Kruger » Tue Jun 04, 2019 7:32 pm

baalhazor wrote:
Sun Jun 02, 2019 6:12 am
Everything was working perfectly but for reasons I won't go into, I had to re-burn the CNC image to my micro sd. I ran the serial config script. Now STARTCNC.JS gets stuck at "starting the server at http://127.0.11:8000".

I've tried everything imaginable. Tested the serial port, updated everything, etc. Can anyone help me?
I know it does not like to be run multiple times.

How long did you wait for it to start up... I know it sometimes takes a while to start.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest