Universal G-code sender V2 GRBL 1.1

Question/Answers related to this version of the board.
Post Reply
jnivard
Posts: 5
Joined: Sat Apr 29, 2017 8:32 pm

Universal G-code sender V2 GRBL 1.1

Post by jnivard » Mon May 06, 2019 9:41 pm

Hai

I have problems using UG-code sender when I use G91 command. The visualiser is not working correctly.
when I use the G91 command relative addressing. I use relative addressing for code that I have to repeat. But the software can not translate this to proper dimensions. Who has experience with a other software to use in combination with GRBL 1.1

Kind regards
John

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest