Cloned Y axis Issue

Post Reply
usajet
Posts: 1
Joined: Sun Dec 23, 2018 1:00 am

Cloned Y axis Issue

Post by usajet » Sun Dec 23, 2018 1:03 am

I solder the jumpers on the Y axis as instructed and when I push the Y+ or Y- in bcnc it goes the same direction. Any Ideas?


Thank You
Nathan

Bertus Kruger
Site Admin
Posts: 1357
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Cloned Y axis Issue

Post by Bertus Kruger » Wed Dec 26, 2018 7:17 am

Could you please post a photo of your clone settings? (Looks like the Direction pin is not correct)

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests