Board 2.11 and Nano Arm

Post Reply
TSMaker83
Posts: 1
Joined: Sat Aug 05, 2017 5:29 pm

Board 2.11 and Nano Arm

Post by TSMaker83 » Sat Aug 05, 2017 7:11 pm

Hello I have been doing a lot of research on the arduino due lately and stumbled on to this page.
Would it be possible to run the Nano Zero Arm on a 2.11 board?

Bertus Kruger
Site Admin
Posts: 1705
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Board 2.11 and Nano Arm

Post by Bertus Kruger » Mon Aug 07, 2017 6:47 pm

No... the problem is that the NANO-ARM is running at 3V3 volt and the Original NANO get supplied 5V.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests