- Posts: 1
- Joined: Sat Aug 05, 2017 5:29 pm
Hello I have been doing a lot of research on the arduino due lately and stumbled on to this page.
Would it be possible to run the Nano Zero Arm on a 2.11 board?
- Site Admin
- Posts: 1705
- Joined: Wed Feb 03, 2016 10:26 pm
- Location: Wellington , New Zealand
No... the problem is that the NANO-ARM is running at 3V3 volt and the Original NANO get supplied 5V.
Who is online
Users browsing this forum: No registered users and 1 guest