5V, e-stop, resume, hold, abort on version 2.11 board

Post Reply
tomsepe
Posts: 1
Joined: Mon Feb 27, 2017 4:48 am

5V, e-stop, resume, hold, abort on version 2.11 board

Post by tomsepe » Mon Feb 27, 2017 4:54 am

Please explain the pins on the bottom of the 2.11 version board.
5V -- NC
E-STOP -- NC
RESUME -- GND
HOLD -- GND
ABORT -- GND

I am assuming that a switch is connected between these pins to activate these features?

Does do each of these then send a specific Gcode command to the arduino running GRBL or are these pins connected to the raspberry pi?

I looked on the wiki but there was no detailed explanation of how to use these pins.

Thanks

Bertus Kruger
Site Admin
Posts: 1705
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: 5V, e-stop, resume, hold, abort on version 2.11 board

Post by Bertus Kruger » Wed Mar 01, 2017 6:56 pm

Abort, Hold, Resume are all linked pins that GRBL checks and acts on. No G-Code involved and part of GRBL code.

E-STOP is the emergency stop that reset the Microcontroller.,

Abort, Hold, Resume gets activated when connected to ground.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest