Hi,
I am needing help setting up auto square.
Setup: CNC Shield v3, Dual Y Motors using separate drivers, Y and A.
I am using end stops now, however, I only have one end stop wired for the first Y motor that uses the Y driver. I would like to use a second end stop for the other Y motor that is connected to the A driver. This way it will auto square. How do I go about wiring that on the shield and configuring that in GRBL?
Thank you for your help.
Auto Square
-
- Site Admin
- Posts: 1336
- Joined: Wed Feb 03, 2016 10:26 pm
- Location: Wellington , New Zealand
- Contact:
Re: Auto Square
The Y end stops on the board have two sets of end stop connectors per axis. Just use the second one...


Re: Auto Square
Hi,
Thank you for the reply. I know about the 2 end stop pins per axis. I guess this is more of a software issue? As in, how to setup the software to use the second end stop pin for the cloned motor.
Thank you.
Thank you for the reply. I know about the 2 end stop pins per axis. I guess this is more of a software issue? As in, how to setup the software to use the second end stop pin for the cloned motor.
Thank you.
Who is online
Users browsing this forum: No registered users and 1 guest