Adapting a 3D Printer Board

Post Reply [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Filamax
Posts: 4
Joined: Tue Mar 16, 2021 10:30 am
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Adapting a 3D Printer Board

Post by Filamax » Mon Apr 05, 2021 3:09 am

Hey Guys,

While working on fixing a bug in GRBL, I was pondering could I fork the GRBL Mega branch and have a specific version of the firmware to work on the Aus3D RUMBA Plus board. Its quite a full featured board, and would make a good candidate for a GRBL board, but I would need to adjust the pins setup to match the board layout.

Now doing this is not to much of a difficult task, as I know the boards designer personally.

But its not a ramps stack, so it has headers for i2c, the graphics lcd etc.

So a bit of work ahead of me, I would be open to people helping me on this endeavour.

Regards
Paul

Post Reply [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Who is online

Users browsing this forum: No registered users and 2 guests