Page 1 of 1

Board orientation and connection plugs.

Posted: Sun Apr 11, 2021 6:40 am
by marsheng
Just purchased my Arduino shield and 4 x DRV8825 . Very pleased to see these are designed in NZ. I got them from Trademe, Hopefully they are authorized suppliers.

A few issues.

I can't find any marks in the board or info on which way the DRV8825 are to be mounted.
What style/part number/Digikey number connectors are used to connect to the outputs to steppers, limit switches and where can these be bought from?
It would be nice if the board came with a packet of jumpers.

Thanks Wallace.
Christhchurch.

Re: Board orientation and connection plugs.

Posted: Fri Apr 16, 2021 8:52 am
by Bertus Kruger
Hi... What version of the board do you have?

The enable pin in next to where the little capacitors(Coke cans) leads go into the board.