SCL line question

Question/Answers related to this version of the board.
Post Reply
BESM
Posts: 2
Joined: Mon Nov 16, 2020 3:39 pm

SCL line question

Post by BESM » Wed Nov 18, 2020 2:00 pm

Using a 3.51 ver Shield and am having difficulty with I2C communication and it appears to be due to a loading on the SCL line.

With the shield not plugged into the UNO, the SCL line has a measured resistance to ground of 10.6K.
It looks like this is related to one of the LED's on the board, to which it shows continuity.
I would like to clear this loading but before I do any surgery, I would like to know the specific reason for this loading resistance. I really just want a clean connection to A5 with nothing hanging off it.

Perhaps a circuit diagram showing the LED arrangement would be helpful.

I am using the shield as a basis for 3 steppers but not for CNC.

Any advice would be appreciated

Thanks

Bruce M

Boston MA

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest