Reversable Spindle Driver

Question/Answers related to this version of the board.
Post Reply
Posts: 3
Joined: Mon Jul 09, 2018 5:56 am

Reversable Spindle Driver

Post by marcwolf » Mon Jul 09, 2018 6:11 am

Hi Folks.
I'm a newbie to CNC but have a lot of experience with my TEVO Black Widow and it's added 7W laser unit.

Just finished building my C-BEAM CNC and wiring it up. Currently using a cheapie Arduino CNC board but have a 3.51 on order. I have decided to use TB6600's rather than the onboard stepper drivers though I run TMC2100 on my Tevo.

What I have not been able to find is a reversable spindle drive board. All of them are one direction unless I use the SpinDir to run a H Bridge after the PWM Controller.

Any Suggestions Folks.

Many thanks

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest