I'm a newbie to CNC but have a lot of experience with my TEVO Black Widow and it's added 7W laser unit.
Just finished building my C-BEAM CNC and wiring it up. Currently using a cheapie Arduino CNC board but have a 3.51 on order. I have decided to use TB6600's rather than the onboard stepper drivers though I run TMC2100 on my Tevo.
What I have not been able to find is a reversable spindle drive board. All of them are one direction unless I use the SpinDir to run a H Bridge after the PWM Controller.
Any Suggestions Folks.
Question/Answers related to this version of the board.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest