lathe screwcutting

Question/Answers related to this version of the board.
Post Reply
fence
Posts: 1
Joined: Thu Oct 05, 2017 9:02 am

lathe screwcutting

Post by fence » Thu Oct 05, 2017 11:57 am

Am i insane thinking about (with the use of a good vsd for spindle control), sending a feed hold prior to starting a screw cutting pass -then using a single pulse per rev signal tied to a pin to command a resume command?. -This is all hypothetical, and i will build and try this in the next few months. Of course spindle speed would be around 300rpm and checked for repeatability.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests