Board orientation and connection plugs.

Question/Answers related to this version of the board.
Post Reply
marsheng
Posts: 1
Joined: Sat Apr 03, 2021 10:27 am

Board orientation and connection plugs.

Post by marsheng » Sun Apr 11, 2021 6:40 am

Just purchased my Arduino shield and 4 x DRV8825 . Very pleased to see these are designed in NZ. I got them from Trademe, Hopefully they are authorized suppliers.

A few issues.

I can't find any marks in the board or info on which way the DRV8825 are to be mounted.
What style/part number/Digikey number connectors are used to connect to the outputs to steppers, limit switches and where can these be bought from?
It would be nice if the board came with a packet of jumpers.

Thanks Wallace.
Christhchurch.

Bertus Kruger
Site Admin
Posts: 1776
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Board orientation and connection plugs.

Post by Bertus Kruger » Fri Apr 16, 2021 8:52 am

Hi... What version of the board do you have?

The enable pin in next to where the little capacitors(Coke cans) leads go into the board.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests