Clone drive direction

[Dlmiller2005]

The Wiki isn't clear on what direction solder tab default is clockwise or counter clockwise.

[Bertus Kruger]

The Clone jumpers does not change the direction the motors turn.

Potential issues:
# The Clone Direction Jumper is not soldered properly.

[Mochanic]

I was confused BEFORE I found this old post, now I REALLY confused!!!

So let's say I want to clone my Y axis, your telling me I MUST solder both jumper pads? What if one of my motors is running backwards, I cannot simply change the direction by either soldering or unsoldering the DIR jumper pad? (isn't that why it's called a direction jumper pad?)
The WIKI REALLY needs to clarify this!

[erniehatt]

If it is running backwards, just reverse the motor cables.

[Dougie]

If you reverse both wires for just one of the coils (A or B) you will change the direction of the movement.