In the wiki the voltage for the motor controllers listed as 12-36v. The DRV8825 controller can handle 48v is this a limitation of the 2.60 board? Can 48v be run through it safely?
Thanks!
Voltage for Pololu DRV8825
-
- Site Admin
- Posts: 1773
- Joined: Wed Feb 03, 2016 10:26 pm
- Location: Wellington , New Zealand
- Contact:
Re: Voltage for Pololu DRV8825
We tested the V2.60 at 36v. For compatibility we labeled it at 36V for other pololu stepper drivers that don't go that high.BluePenguinGuitars wrote: ↑Thu Feb 25, 2021 6:17 amIn the wiki the voltage for the motor controllers listed as 12-36v. The DRV8825 controller can handle 48v is this a limitation of the 2.60 board? Can 48v be run through it safely?
Thanks!
The board should technically be able to do it... The Caps on each stepper socket is rated for 50V but in my opinion the extra 2V is cutting it close.
-
- Posts: 7
- Joined: Thu Feb 25, 2021 6:10 am
Re: Voltage for Pololu DRV8825
Thank you, makes sense now that you explain it.
Who is online
Users browsing this forum: No registered users and 1 guest