bCNC no Connection with Grbl (Raspberry Pi 3)

[$imon]

Hallo,

First the Setup:
Protoneer CNC = V2.60
Raspberry Pi 3 B+
bCNC = V 0.9.14

I configured the serial Port s with the "RPi3 Serial Config" and it worked well. Now the Port is changed to "/dev/ttyS0".
Then i tried to start with bCNC. The connection with the Serial Port worked, but i did not connected with Grbl.

Bildschirmfoto 2021-01-08 um 17.06.06.png (80.56 KiB) Viewed 21 times

On this point i need some help.
Is there any option to check or configured Grbl ?

Thanks

[Bertus Kruger]

Yes, there is a shortcut to miniterm that allows you to directly connect to GRBL. Just keep in mind only one connection can be made at a time.(Or apps will start to block each other from accessing the serial port.)

HAve you tried connecting to /dev/ttyAMA0 ?