using the lefto over GPIOs to switch on relays

Post Reply
PropellerHat
Posts: 8
Joined: Fri Jun 19, 2020 11:09 am

using the lefto over GPIOs to switch on relays

Post by PropellerHat » Fri Jun 19, 2020 11:14 am

Hi

I am trying to come up with the simplest way to command relays with the gpio pins that are not in use for the HAT. The sweetest possibility would probably be custom M codes that would then change the state of a given pin but I have 0 coding skills and would need something to copypaste to get this done. Anybody did it already and would be interested in sharing the lines?

Is there any other way to automate the mill a bit more? basically I´m looking into automated stock loading and later an ATC.

Thanks!

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests