large file stops running

Post Reply
Posts: 1
Joined: Mon Jul 15, 2019 2:08 am

large file stops running

Post by westberrymfg » Mon Jul 15, 2019 2:29 am

So there seems to be a limit to file size, 33.89KB works, 37.36KB does not.
Yes, ive adjusted redraw time to the max, that helped and I ran the gpu memory to the max, that helped.
There is no difference in the two files as far as operation.
I'm using Raspberry Pi3 B+ and booting off a 1 tera bit hard drive instead of a card with bcnc.
The machine goes to idle and waits for respond. If I open the code and uncheck previous blocks that have run and press resume the file continues for a moment.
Also, if I do not delete the 2nd line of code in the header which is O0 the files does not run at all.
Any ideas here?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest