GRBL

Post Reply
Dlmiller2005
Posts: 12
Joined: Fri Feb 23, 2018 12:19 am

GRBL

Post by Dlmiller2005 » Fri Feb 08, 2019 10:07 pm

What version of GRBL is installed on the 2.60 version?

When connecting to the controller with Arduino application what do I use for the Board, Processor and Port?

Bertus Kruger
Site Admin
Posts: 1395
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: GRBL

Post by Bertus Kruger » Sun Feb 10, 2019 6:27 pm

GRBL V1.1

Board: Arduino Uno
port : /dev/ttyAMA0

Dlmiller2005
Posts: 12
Joined: Fri Feb 23, 2018 12:19 am

Re: GRBL

Post by Dlmiller2005 » Tue Feb 12, 2019 11:08 pm

I have tried every combination possible to talk to the hat using Arduino GUI.

Nothing works...

berin
Posts: 34
Joined: Sun Sep 02, 2018 4:32 pm

Re: GRBL

Post by berin » Wed Feb 13, 2019 9:14 pm

What is your setup... What board do you have... makes a huge difference depending on what proto board(s) you own. Some setups like the RPI protoneer board expect you to run arduino IDE on the RPI its self and update via direct plugged in connection. other boards that use arduinos expect you to connect to them using there own USB connection or an ICSP cable with an FTDI programmer or an arduino uno with a programming script and a CAP on the reset pin. there are a lot of combinations and more that I do not even know about. If you can fill in some of the details you may find joy with someones help.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest