Headless bCNC operation

Post Reply
plyoteo
Posts: 3
Joined: Thu Nov 12, 2020 4:59 pm

Headless bCNC operation

Post by plyoteo » Sun Nov 15, 2020 12:08 pm

In headless mode, could one start bCNC with Putty by typing $ python -m bCNC or $ bCNC -g 800X480? So far I have been unable to. The only way is through VNC, either by clicking on the shortcut icon or by opening the CMD window and typing one of the above commands.

Thank you in advance for any input.

Bertus Kruger
Site Admin
Posts: 1785
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Headless bCNC operation

Post by Bertus Kruger » Sun Nov 29, 2020 6:19 pm

Was not aware that you could run bCNC headless....

My understanding was that you need a screen for it.

plyoteo
Posts: 3
Joined: Thu Nov 12, 2020 4:59 pm

Re: Headless bCNC operation

Post by plyoteo » Thu Apr 29, 2021 5:48 am

Sorry for the possible misnomer. What i meant by 'headless' is not physically attached to a raspberry screen, but accessed via putty ssh/vnc from a pc or laptop.

Bertus Kruger
Site Admin
Posts: 1785
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Headless bCNC operation

Post by Bertus Kruger » Fri May 21, 2021 1:05 am

bCNC needs a screen to operate. So it will need to be VNC and it will only be able to run after connecting.

Not sure if Linux has a way to do that....

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest