v5.0 software on Protoneer board 2.58

Post Reply
wrongway1953
Posts: 1
Joined: Tue Feb 19, 2019 11:44 am

v5.0 software on Protoneer board 2.58

Post by wrongway1953 » Sun Mar 01, 2020 5:19 am

I downloaded version 5.0 last night and tried to unzip it this morning. But it came up with an error warning saying file could not be opened or is not a valid Zip File.

Bertus Kruger
Site Admin
Posts: 1649
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: v5.0 software on Protoneer board 2.58

Post by Bertus Kruger » Wed Mar 04, 2020 6:30 pm

wrongway1953 wrote:
Sun Mar 01, 2020 5:19 am
I downloaded version 5.0 last night and tried to unzip it this morning. But it came up with an error warning saying file could not be opened or is not a valid Zip File.
Thanks for your feedback. What Operating System are you using? How are you unzipping it?

onelonedork
Posts: 27
Joined: Sun Aug 27, 2017 7:10 pm

Re: v5.0 software on Protoneer board 2.58

Post by onelonedork » Tue Apr 07, 2020 3:33 am

I am upgrading from a pi 3b to pi 4, bcnc works fine on my 3b .img, but bcnc comm's seem as though they aren't communicating on pi 4. Am i missing something?

Bertus Kruger
Site Admin
Posts: 1649
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: v5.0 software on Protoneer board 2.58

Post by Bertus Kruger » Sun Apr 12, 2020 10:21 pm

onelonedork wrote:
Tue Apr 07, 2020 3:33 am
I am upgrading from a pi 3b to pi 4, bcnc works fine on my 3b .img, but bcnc comm's seem as though they aren't communicating on pi 4. Am i missing something?
I have just updated the image to V5.1 and tested it on my RPI without issues.

Just run the Raspberry Pi 3/4 config script on the desktop. (It will restart and then bCNC should be fine)

onelonedork
Posts: 27
Joined: Sun Aug 27, 2017 7:10 pm

Re: v5.0 software on Protoneer board 2.58

Post by onelonedork » Thu Apr 30, 2020 3:19 pm

Thanks that did it!

Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests