PWM connection

Bertus Kruger
Site Admin
Posts: 1490
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: PWM connection

Post by Bertus Kruger » Sun May 26, 2019 7:34 pm

erniehatt wrote:
Fri May 17, 2019 7:50 am
Update2.
Come to think about it, it's probably just jumper across from the X to the Z
Have a few minor things to do, then I will upload a pic of it.
;)

erniehatt
Posts: 245
Joined: Thu Nov 03, 2016 8:16 am

Re: PWM connection

Post by erniehatt » Mon May 27, 2019 3:45 am

Thanks Bertus,
It seems to be the z axis side that is not working, so I tried a new driver, still not go, so I have ordered a new Hat, only hope it is that and not the PI itself.

Bertus Kruger
Site Admin
Posts: 1490
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: PWM connection

Post by Bertus Kruger » Thu May 30, 2019 7:34 pm

erniehatt wrote:
Mon May 27, 2019 3:45 am
Thanks Bertus,
It seems to be the z axis side that is not working, so I tried a new driver, still not go, so I have ordered a new Hat, only hope it is that and not the PI itself.
The Pi should be okay. Its only connected with the serial pins and if the Pi and the board can communicate it is still working.

erniehatt
Posts: 245
Joined: Thu Nov 03, 2016 8:16 am

Re: PWM connection

Post by erniehatt » Sat Jun 01, 2019 7:41 am

That's a relief Bertus.
Then it can only be the hat that is damaged, as I did try a new Driver.
Cheers

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest