installing UGS on PI3

Whittler
Posts: 52
Joined: Mon Sep 26, 2016 2:26 pm

Re: installing UGS on PI3

Post by Whittler » Thu Jan 26, 2017 4:33 pm

I have a virgin Raspberry Pi 3, a brand new CncHat with old firmware, and new 32Gb SD card. I'll give the image install and CncHat upgrade another try on fresh hardware this weekend for another project I want to do.
Research is the only place in a company where you can continually have failures and still keep your job.
I knew immediately that was where I belonged.

ugurbircan
Posts: 1
Joined: Sun Jan 12, 2020 2:36 pm

Re: installing UGS on PI3

Post by ugurbircan » Sun Jan 12, 2020 2:41 pm

Hi,
Link dont work. You have alternative?

Bertus Kruger
Site Admin
Posts: 1649
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: installing UGS on PI3

Post by Bertus Kruger » Thu Jan 16, 2020 6:28 pm

ugurbircan wrote:
Sun Jan 12, 2020 2:41 pm
Hi,
Link dont work. You have alternative?
What link is that?

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests