Drive question

Post Reply
erniehatt
Posts: 212
Joined: Thu Nov 03, 2016 8:16 am

Drive question

Post by erniehatt » Fri Mar 15, 2019 9:42 pm

As said earlier, I am rebuilding My CNC.
I am going with a 3D printer type design, I am not quite sure which way to go. The Y base plate is aluminium 380 X 280 X 5 mm, not that heavy, but you also have to allow for Material size and weight.
I am using Nema23 motors with TB6500 drivers, I would like to go with a single belt drive, but am not sure if this would be efficient enough.
I used threaded rods on the previous model but was not overly impressed with the outcome, hence the rebuild, the whole thing was way to heavy, the Y axis drove the whole workings, here it will be separate..
Any advice here would be highly appreciated. Thanks

Bertus Kruger
Site Admin
Posts: 1360
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Drive question

Post by Bertus Kruger » Sun Mar 17, 2019 6:12 pm

erniehatt wrote:
Fri Mar 15, 2019 9:42 pm
As said earlier, I am rebuilding My CNC.
I am going with a 3D printer type design, I am not quite sure which way to go. The Y base plate is aluminium 380 X 280 X 5 mm, not that heavy, but you also have to allow for Material size and weight.
I am using Nema23 motors with TB6500 drivers, I would like to go with a single belt drive, but am not sure if this would be efficient enough.
I used threaded rods on the previous model but was not overly impressed with the outcome, hence the rebuild, the whole thing was way to heavy, the Y axis drove the whole workings, here it will be separate..
Any advice here would be highly appreciated. Thanks
Lead screws work well and will deal with higher loads. They also have good mounting blocks.
Image

erniehatt
Posts: 212
Joined: Thu Nov 03, 2016 8:16 am

Re: Drive question

Post by erniehatt » Sun Mar 17, 2019 8:58 pm

Thanks Bertus,
Agree rods are a good method, but can be difficult to line up, especially if you are using two.
So I have made the decision to go with two belt drives, using 10mm wide belts, for the Y axis can't be any worse than what I already had.
One more question, can I drive two motors on the Z axis from the one TB6500 DRIVER, I can do this on the printer no problem using normal drivers. :?

Bertus Kruger
Site Admin
Posts: 1360
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Drive question

Post by Bertus Kruger » Tue Mar 19, 2019 6:14 pm

erniehatt wrote:
Sun Mar 17, 2019 8:58 pm
One more question, can I drive two motors on the Z axis from the one TB6500 DRIVER, I can do this on the printer no problem using normal drivers. :?
I can not see why not... ;)

erniehatt
Posts: 212
Joined: Thu Nov 03, 2016 8:16 am

Re: Drive question

Post by erniehatt » Thu Mar 21, 2019 3:47 am

Thanks Mate, let you know how it works out.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest