v3.0 CNC Shield in K40 help please

Post Reply
CustomCreations
Posts: 1
Joined: Fri Feb 01, 2019 11:29 pm

v3.0 CNC Shield in K40 help please

Post by CustomCreations » Fri Feb 01, 2019 11:34 pm

I am trying to configure my v3.00 CNC shield to work in my K40 laser as the old board was DOA. I have GRBL 1.1f loaded onto shield and now I am trying to figure out where the connections go and what settings need to be configured for the laser to work and fire. After some reading, I have noticed that the laser fires on a 0v and disables on 5v so I do not know if I have to build another circuit for this or if it can be inverted in GRBL. ANY and all help is greatly appreciated!

TIA!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest