Arduino due mod

Post Reply
Keithwg08
Posts: 1
Joined: Wed Nov 07, 2018 6:40 pm

Arduino due mod

Post by Keithwg08 » Wed Nov 07, 2018 6:58 pm

If I'm reading the schematic correctly....

To make the board 3.3v logic.
Snip the 5v pin on the bottom of the board.
Solder jumper it to the 3.3v pin on the top.

That should remove 5v on everything and give them 3.3 instead? Am I right?
If it does, you really should consider a logic level jumper on the board. It would be so awesome to have a board that'll work with the 32 bit Arduinos out of the box.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest