Validation of manufacturer

Post Reply
DavePfz
Posts: 3
Joined: Tue Sep 03, 2019 5:15 pm

Validation of manufacturer

Post by DavePfz » Thu Sep 05, 2019 12:28 pm

How can I know that a CNC shield is from Protoneer versus a knock-off?

Bertus Kruger
Site Admin
Posts: 1475
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Validation of manufacturer

Post by Bertus Kruger » Wed Sep 11, 2019 7:32 pm

DavePfz wrote:
Thu Sep 05, 2019 12:28 pm
How can I know that a CNC shield is from Protoneer versus a knock-off?
The V3.51 is only sold by Protoneer and distributors. clones are all of V3.00

DavePfz
Posts: 3
Joined: Tue Sep 03, 2019 5:15 pm

Re: Validation of manufacturer

Post by DavePfz » Wed Sep 11, 2019 10:42 pm

OK. As I worked with the board I have, I found too many quality issues (cold solder joints, broken traces, and sockets with bad connections) and finally just ordered the "real McCoy."

I should have it in a week or so.

Thanks.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest