Launch CNCjs automatically at startup

Post Reply
StefLag67
Posts: 2
Joined: Wed Dec 02, 2020 2:11 pm

Launch CNCjs automatically at startup

Post by StefLag67 » Thu Feb 04, 2021 7:22 am

Hi there,
what is the process to launch automatically CNCjs when the RPi starts up?

Thanks!

Bertus Kruger
Site Admin
Posts: 1779
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Launch CNCjs automatically at startup

Post by Bertus Kruger » Mon Feb 08, 2021 6:43 pm

I have used crontab in the past but below is a list of options...

https://www.dexterindustries.com/howto/ ... t-startup/

Bertus Kruger
Site Admin
Posts: 1779
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Launch CNCjs automatically at startup

Post by Bertus Kruger » Mon Feb 08, 2021 6:44 pm

Keep in mind that if you auto start stuff they will lock up the serial port and you might have to manually stop them if you want to use the serial port with other software

StefLag67
Posts: 2
Joined: Wed Dec 02, 2020 2:11 pm

Re: Launch CNCjs automatically at startup

Post by StefLag67 » Fri Feb 12, 2021 1:45 pm

Bertus Kruger wrote:
Mon Feb 08, 2021 6:43 pm
I have used crontab in the past but below is a list of options...

https://www.dexterindustries.com/howto/ ... t-startup/
thanks, super helpful

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest