Default compilation and GRBL Shield Output Pins

Please share your projects...
Post Reply
bringho
Posts: 1
Joined: Fri Dec 25, 2020 4:04 pm

Default compilation and GRBL Shield Output Pins

Post by bringho » Fri Dec 25, 2020 5:05 pm

Today I ordered the latest GRBL shield to replace my (probably Chinese clone) GRBL 3.00 board
that was delivered with my Raw 1.5 DIY CNC kit.

Having had some trouble getting thinks to work I finally figured out that there are some discrepancy
regarding pinout on the 3.00 shield and the default compilation options in the grbl firmware.

As far as I can see by looking at images the same seem to be the case with the current version of the Shield
but it will be some time until I can verify that.

I created this document for any having the same problem in the future =)

https://www.dropbox.com/s/f72e838bfz1zh ... p.pdf?dl=0

Bertus Kruger
Site Admin
Posts: 1769
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Default compilation and GRBL Shield Output Pins

Post by Bertus Kruger » Mon Jan 04, 2021 7:34 pm

Thanks for that.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest