Pine64 in place of Pi?

Please share your projects...
Post Reply
Sendero
Posts: 1
Joined: Tue Feb 25, 2020 5:25 pm

Pine64 in place of Pi?

Post by Sendero » Tue Feb 25, 2020 6:01 pm

Has anyone tried using a different board with a rPi header like the Pine64? I have one of these pine64 boards in a small enclosure w/ touch screen and it is just collecting dust. I had tried in the past to use it with UGS to a cheap 3018 machine through USB, but it kept disconnecting while sending the code. I came across the cnc hat while looking into building a new machine. I have never used the rPi header on the board, but I have tinkered some with the euler bus.

Bertus Kruger
Site Admin
Posts: 1769
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Pine64 in place of Pi?

Post by Bertus Kruger » Tue Feb 25, 2020 6:36 pm

I have not used it on other Pi like boards, but if there are pin compatible there is no reason they will not work.

The main thing is to check that the serial pins are the same...

GPIO 14 anf 15 are the main serial pins. The top 5V , 3.3V and Ground pins also needed.

Image

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest