Protoneer V2.6 and Nanodlp

Please share your projects...
Post Reply
Envey
Posts: 1
Joined: Mon Sep 24, 2018 2:44 am

Protoneer V2.6 and Nanodlp

Post by Envey » Mon Sep 24, 2018 2:49 am

Newbie here and I am trying to setup nanodlp for sla printer. running brand new proto board on rpi 3 B+ have everything working with BCNC but when I switch to nanodlp installed SD It dose nothing. When I run logger I get this "2018/09/15 19:28:52.819655 {"Layer":"0","module":"SLAVE","level":"Error","msg":"Serial port could not be activated no such file or directory"}" Can anyone help? has anyone tried this?

Any help would be great.

Bertus Kruger
Site Admin
Posts: 1252
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Protoneer V2.6 and Nanodlp

Post by Bertus Kruger » Sun Sep 30, 2018 5:58 pm

most likely because the serial port is not configure.

This script should fix it... : https://raw.githubusercontent.com/Proto ... -Config.sh

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests