Can anyone help with tinkerboard setup instead of using pi3

Please share your projects...
Post Reply
r4ffers
Posts: 1
Joined: Thu Oct 15, 2020 6:52 pm

Can anyone help with tinkerboard setup instead of using pi3

Post by r4ffers » Fri Oct 16, 2020 6:20 pm

Hi folks, I'm new to this stuff. I have successfully setup my pi3 with v2.6 board using the sd card image.im using 3d printed topsie cnc router from thingiverse.
I have just ordered a tinkerboard which id like to try instead of the pi.
Do I just install the tinker os and bcnc?
I believe the gpio pins are the same.

Any help is greatly appreciated

Bertus Kruger
Site Admin
Posts: 1710
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Can anyone help with tinkerboard setup instead of using pi3

Post by Bertus Kruger » Mon Oct 19, 2020 5:54 pm

I think the main thing would be to establish if the hardware serial port is working on the new board.

bCNC should work fine on most Linux versions.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest