Page 1 of 1

Board 2.11 and Nano Arm

Posted: Sat Aug 05, 2017 7:11 pm
by TSMaker83
Hello I have been doing a lot of research on the arduino due lately and stumbled on to this page.
Would it be possible to run the Nano Zero Arm on a 2.11 board?

Re: Board 2.11 and Nano Arm

Posted: Mon Aug 07, 2017 6:47 pm
by Bertus Kruger
No... the problem is that the NANO-ARM is running at 3V3 volt and the Original NANO get supplied 5V.