Question/Answers related to this version of the board.
Post Reply
Posts: 21
Joined: Sat Oct 22, 2016 2:23 pm


Post by rmasci » Tue Dec 06, 2016 1:25 am

Hi Does the probe work? I connected the probe on my xcarve to the probe / ground pins on the CNC Board... I am using xcarve-server / xcarve-proxy so Inventables Easel program can control through the Pi CNC Board. I can do test cuts, and use the homing switches, but When I ran the probe setup it didn't do anything. I double checked the wires and they're connected ok. Anything I can do?



Bertus Kruger
Site Admin
Posts: 1670
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand

Re: Probe?

Post by Bertus Kruger » Tue Dec 06, 2016 7:02 pm

I have not played with it much but I have seen a few people use it with bCNC before...

Posts: 135
Joined: Wed Nov 09, 2016 8:52 pm

Re: Probe?

Post by gmoney484 » Wed Mar 01, 2017 7:52 pm

I've successfully used the probes and bCNC to auto level a PCB for milling. Needed no complex set up. Just making sure the z height was correct and zeroed. Worked really well.
Gavin Milne
HoD Science
Dilworth School

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest