Search found 3 matches

by radar
Thu May 19, 2016 2:54 pm
Forum: Old CNC Shield V3.00 and Chines copies of it...
Topic: CNC shield v3.0 vs GRBL 0.9 (pins D11 vs D12)
Replies: 3
Views: 4036

Re: CNC shield v3.0 vs GRBL 0.9 (pins D11 vs D12)

I have tried and I confirm, that works perfectly!Thanks.
by radar
Tue May 10, 2016 6:23 am
Forum: Old CNC Shield V3.00 and Chines copies of it...
Topic: CNC shield v3.0 and fuse replacement
Replies: 6
Views: 13160

CNC shield v3.0 and fuse replacement

When I adjust load current for stepper motor, I accidentally burn out fuse on my cnc shield. I know it is possible replace fuse with piece of wire, but I don't want burn out other (expensive) things (I tested Arduino, CNC shield and stepper driver after this incident and all is OK, fortunatelly). Wh...
by radar
Fri Apr 22, 2016 6:31 am
Forum: Old CNC Shield V3.00 and Chines copies of it...
Topic: CNC shield v3.0 vs GRBL 0.9 (pins D11 vs D12)
Replies: 3
Views: 4036

CNC shield v3.0 vs GRBL 0.9 (pins D11 vs D12)

I have bought CNC shield v3.0 but in GRBL ver 0.9+ are pins D11 and D12 reverse. I need control spindle on/off via Gcode and I'm using limit switches too. Is it possible to run CNC shield v3.0 with GRBL ver 0.9, when I simply connect my spindle control to pin for limit Z axis and limit switch for Z ...