reset button orientation

Question/Answers related to this version of the board.
Post Reply
Korimako
Posts: 2
Joined: Tue Jan 03, 2017 8:18 am

reset button orientation

Post by Korimako » Tue Jan 03, 2017 8:34 am

Hi, newbie question, when soldering on the reset button does it matter which way around it goes? the pins are rectangular in formation so there are only two ways it can go and the instructions dont specify if the orientation matters.
Thank you :D

Bertus Kruger
Site Admin
Posts: 681
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: reset button orientation

Post by Bertus Kruger » Wed Jan 04, 2017 8:31 am

To activate the Reset the pin needs to be connected to ground.

A simple always open switch connected between reset and ground pins should do the job.(No polarity to worry about.)

Korimako
Posts: 2
Joined: Tue Jan 03, 2017 8:18 am

Re: reset button orientation

Post by Korimako » Thu Apr 20, 2017 7:38 am

Thank you :-)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest