TCM2100 running on a RPi CNC Hatt

Post Reply
Bertus Kruger
Site Admin
Posts: 737
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

TCM2100 running on a RPi CNC Hatt

Post by Bertus Kruger » Sun Jun 18, 2017 7:42 am

A few weeks ago I was asked if TCM2100 Silent Stepper drivers will run on the RPi CNC Hat.

Back then I did not have any TCM2100 stepper drivers but I finally managed to test it.

https://youtu.be/wC0or3VYpgA

Must say they are really silent!! :)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest