Dual steppers on both X & Y?

Henrik
Posts: 1
Joined: Wed Feb 15, 2017 8:59 pm

Dual steppers on both X & Y?

Postby Henrik » Wed Feb 15, 2017 9:19 pm

Hi,

I´ve searched but not found a solution. Lets see if someone here can help?

What would be the best way to drive dual steppers for both x- and y axis? I would like them to be on the same signal but each stepper connected to a separate A4988.

Is it possible to modify the CNC-shield (v.3) in order to clone X or Y not only to A, but also to Z (i.e. I will not drive a Z-axis)?

I´m planning on building an H-bot prototype with four stepper motors btw...

Many thanks!

Bertus Kruger
Site Admin
Posts: 633
Joined: Wed Feb 03, 2016 10:26 pm
Location: Wellington , New Zealand
Contact:

Re: Dual steppers on both X & Y?

Postby Bertus Kruger » Thu Feb 16, 2017 11:29 pm

ITs possible...

Just clone one to the A and the other via wires connect the step,dir,enable and gnd pins to two drivers.


Return to “Old CNC Shield V3.00 and Chines copies of it...”

Who is online

Users browsing this forum: No registered users and 1 guest